Section 2.8.3
A procedure is a series of steps followed in a regular, definite order to achieve a specified result. The goal of a written procedure is to enable a user to carry out an action with which he or shemight not be familiar. Procedures save the writer time, transfer expertise, ensure consistency,and prevent errors and accidents. Procedures may amount to a single sheet for assembling atable, a lengthy manual of operating routines for a nuclear reactor, or a computer manual full ofroutines for using an operating system like UNIX or DOS.
A procedure is generally organized as follows:
- Purpose and scope. States what the procedure accomplishes and the extent of its application.
- Preliminary requirements. Identifies any items such as documents, personnel, special tools, approvals, field preparations needed to perform the procedure.
- Warnings. Includes any dangerous aspects in performing the procedure.
- Steps. Gives a step-by-step series of actions to be carried out in completing the procedure.
An important aspect of procedures is their extensive use of chunking and step-syntax. Chunking is the sorting of parallel elements into prose sentences orelements that are easily located on the page. Step-syntax is the use of special imperative sentences to identify the action in each step of theprocedure. A typical imperative begins with the action first, as follows:
Cut the end of the cable, as shown in Figure 2-1, removing any sharp wire ends thatprotrude from the jacket.Safety Elements in Procedures
Most instructions contain one or more safety elements. A warning is given before any step thatmay present an element of harm to the individual performing the step. A caution is given beforeany step that could present some risk to equipment. A note is included before or after any stepthat may need some additional explanation.
The Step-Syntax Section of a Procedure
Assembling the Interference Cable Seal
Warning: Do not work with live cables, which may electrocute you.
- Ensure that the cable is not attached to a power source.
- Determine whether or not the optional seal boot will be used and assemble the seal parts (parts list, Section X).
- Cut the end of the cable, as shown in Figure 2-1, removing any sharp wire ends that protrude from the jacket.
Caution: Do not use lubricants that may degrade the cable sheath.
- Apply a light coating of silicone compound, such as DC-55, to several inches of the cable.
- Slide the retaining washer over the cable and push it back out of the way.
- Slide the boot (if used) over the cable and push it back out of the way.
- Slide the seal packing onto the cable.
- Thread the cable the desired amount through the housing bore and out the small opening at the end of the housing.
- Lubricate the outer surface of the packing with silicone compound.
Note: If the packing has been lubricated, the next step is easily accomplished withthumb pressure only. If additional pressure is required, use a blunt rod to squeeze the packinginto the housing.
- Gently squeeze the packing and slide it into the annular space of the housing bore.
- Slide the boot (if used) and retaining washer into place and fasten them with the retaining ring.
- Prepare the end of the cable for making electrical connections.
## Instructions and Procedures ##
[ Home | Table of Contents| Writing Timeline | Index |Help | Credits]
